Remember the easiest way to help support usdualsports is by clicking This Link to Amazon before every purchase and we get a small cut to pay website fees, server fees and the best part is it won't cost you a dime more.
Products Needed:
Sand Paper
Clear Plastic Epoxy - $5.20
Aluminum Foil
Toothpicks
Washable Marker
Rubbing Alcohol
Step 1
Before starting this project make sure you find a good location for your camera. Take into consideration the camera mounting screw, and a position that is out of your line of sight.
Step 2
Mark the mounting position with a washable marker so it can be erased.
Step 3
Sand all areas inside mounting area with sand paper. Then clean with Rubbing Alcohol.
Step 4
Remove red film from GoPro mount and apply mount to desired location.
Step 5
Mix plastic epoxy in accordance to its instructions using a plastic knife. Tip: mix epoxy on aluminum foil, it works great and you can just throw it away.
Step 6
Use your plastic knife to work epoxy into gap between visor and mount. Tip: toothpicks work well at getting out air bubbles, and pushing epoxy into the gap.
Step 7
Once you have filled the gap completely, use tooth picks to scrape extra epoxy off visor.
Step 8
Allow it to dry 24 hours
Have a tip of your own you would like to share with fellow riders? Contact mark@usdualsports.com to have it published.
Have a tip of your own you would like to share with fellow riders? Contact mark@usdualsports.com to have it published.